Tacoma Regular Cab 2WD L4-2438cc 2.4L DOHC MFI (1997)
Axle Nut: Specifications
Install axle hub with disc.
a. Place the axle hub on the spindle.
b. Install the outer bearing and claw washer.
Adjust preload.
a. Install and torque the nut.
Torque to 34 Nm (25 ft. lbs.)
b. Make the bearing smooth by turning the hub several times.
c. Loosen the nut until it can be turned by hand.
d. Using a spring tension gauge, measure and make a note of the frictional force of the oil seal.
HINT: Make sure to check preload in the direction of rotation.
e. Tighten the nut until the preload is within the specification.
Preload (at starting):
Frictional force plus 6 - 18 N (1.3 - 4.0 lbs.)
HINT: Make sure to check preload in the direction of rotation.
f.
Measure the hub axial play.
Axial play: 0.05 mm (0.0020 inch) or less.
