Tacoma Regular Cab 4WD L4-2.7L (3RZ-FE) (1999)
Refrigerant Pressure Sensor / Switch: Service and Repair
REMOVAL
1. REMOVE EVAPORATOR
2. REMOVE PRESSURE SWITCH FROM LIQUID TUBE
Disconnect the connector and remove the pressure switch.
Torque: 10 N.m (100 kgf.cm, 7 ft.lbf)
HINT: Lock the switch mounted on the tube with an open end wrench, being careful not to deform the tube and remove the switch.
At the time of installation, please refer to the following item.
Lubricate a new O-ring with the compressor oil and install the switch.
INSTALLATION
Installation is in the reverse order of removal.