Tacoma Regular Cab 4WD V6-3.4L (5VZ-FE) (1997)
/Page-496005.png)
Alternately loosen the 2 bolts and remove them, then remove the belt tensioner and dust boot.
21. Remove timing belt.
22. Remove RH camshaft timing pulley.
(a)
Using SST Variable Pin Wrench Set # 09960 - 10010 (Variable Pin Wrench Arm Assembly # 09962 - 01000, Pin 10 # 09963 - 01000) or
equivalents, loosen the pulley bolt.
(b) Remove the bolt, knock pin and camshaft timing pulley with timing belt.
23. Remove LH camshaft timing pulley.
(a)
Using SST Variable Pin Wrench Set # 09960 - 10010 (Variable Pin Wrench Arm Assembly # 09962 - 01000, Pin 10 # 09963 - 01000) or
equivalents, loosen the pulley bolt.
(b) Remove the bolt, knock pin and camshaft timing pulley.
24. Remove No. 2 idler pulley.
Remove the bolt and No. 2 idler pulley.
25. Remove No. 1 idler pulley.
Using a 10 mm hexagon wrench, remove the pivot bolt, No. 1 idler pulley and plate washer.
26. Remove crankshaft timing pulley.
NOTE: If the pulley cannot be removed by hand, use SST Puller C Set # 09950 - 50010 (Hanger 150 # 09551 - 05010, Slide Arm # 09552 -
