Tacoma S-Runner 2WD V6-3.4L (5VZ-FE) (2001)
Seat Belt Tensioner: Removal and Replacement
SEAT BELT PRETENSIONER
REMOVAL
CAUTION:
-
When removing the seat belt pretensioner, work must be started 90 seconds after the ignition switch is turned to the "LOCK" position and the
negative (-) terminal cable is disconnected from the battery.
-
Never disassemble the front seat outer belt.
-
Never use seat belt pretensioner from another vehicle. When replacing parts, replace new one.
REMOVE FRONT SEAT OUTER BELT
a. Regular cab, Extra cab:
Remove the quarter trim.
b. Double cab:
Remove the center pillar.
c. Pull the locking button and disconnect the pretensioner connector.
d. Remove the 2 bolts and front seat outer belt with the pretensioner.
Torque:
36 N.m (365 kgf.cm, 27 ft.lbf) for upper bolt
42 N.m (430 kgf.cm, 31 ft.lbf) for lower bolt
INSTALLATION
Installation is in the reverse order of removal procedure.