Tercel/Cor. Tercel L4-1452cc 1AC,3A,3AC (1984)
Ignition Cable: Testing and Inspection
INSPECTION OF HIGH-TENSION CORDS
1. CAREFULLY REMOVE HIGH-TENSION CORDS BY THEIR RUBBER BOOTS FROM SPARK PLUGS
CAUTION: Pulling on or bending the cords may damage the conductor inside.
2. INSPECT HIGH-TENSION CORD RESISTANCE
Using an ohmmeter, measure the resistance without disconnecting the cap.
Maximum resistance: 25 kOhms per cord
If resistance is more than maximum, check the terminals. Replace the high-tension cord and/or distributor cap if necessary.
