Tercel Sedan 4-Door L4-1456cc 1.5L SOHC (3E) (1994)
(a) Remove any old packing (FIPG) material and be careful not to drop any oil on the contact surfaces of the water pump and cylinder block.
-
Using a razor blade and gasket scraper, remove all the old packing (FIPG) material from the contact surfaces and sealing groove.
-
Thoroughly clean all components to remove all the loose material.
-
Using a non-residue solvent, clean both sealing surfaces.
(b) Apply seal packing to the water pump groove.
Seal packing: Part No.08826-00100, THREE BOND 1282B or equivalent
-
Install a nozzle that has been cut to a 2-3 mm (0.08-0.12 in.) opening.
HINT: Avoid applying an excessive amount to the surface.
-
Parts must be assembled within 5 minutes of application. Otherwise the material must be removed and reapplied.
-
Immediately remove nozzle from the tube and reinstall cap.
-
Do not pour in any coolant until at least 2 hours after installation is completed.
(c) Install the water pump with the bolt and 2 nuts.
Torque: 17 N.m (175 kgf.cm, 13 ft.lbf)
2. INSTALL OIL DIPSTICK GUIDE AND GENERATOR ADJUSTING BAR
(a) Install a new 0-ring to the dipstick guide.
(b) Apply soapy water to the 0-ring.