Tercel Sedan 4-Door L4-1456cc 1.5L SOHC (3E) (1994)
/Page-377001.png)
Ignition Cable: Testing and Inspection
1. Disconnect High-tension Cords From Spark Plugs
Disconnect the high - tension cords at the rubber boot. Do not pull on the high-tension cords.
NOTICE: Pulling on or bending the cords may damage the conductor inside.
2. Remove Distributor Cap Without Disconnecting High-tension Cords
3. Inspect High-tension Cord Resistance
Using an ohmmeter. measure the resistance without disconnecting the distributor cap.
Maximum resistance 25 kohms per cord
If the resistance is greater than maximum. check the terminals. If necessary. replace the high-tension cord and/or distributor cap.
4. Reinstall Distributor Cap
5. Reconnect High-tension Cords To Spark Plugs
