toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Drive Belts, Mounts, Brackets and Accessories > < Valve Cover|Specifications
Page 1
background image

Valve Guide: Service and Repair

1.

Using a suitable tool and hammer, strike valve guide bushing to break it off at cylinder head casting.

2.

Heat cylinder head to 176-212°F (80-100°C).

3.

Using suitable valve guide removal tool, tap out bushing.

4.

Install snap ring on new valve guide, then install new valve guide using tool as above and driving in from the reverse side of removal.

5.

Ream new valve guide, if necessary. 

Drive Belts, Mounts, Brackets and Accessories > < Valve Cover|Specifications