Tercel Sedan 4-Door L4-1456cc 1.5L SOHC (3E-E) (1992)
/Page-578004.png)
-
If the lining of the disc is exfoliated or discolored, or even a part of the printed number is defaced, replace all discs.
-
Before assembling new discs, soak them in ATF for at least fifteen minutes.
3. CHECK DIRECT CLUTCH BUSHING
Using a dial indicator, measure the inside diameter of the direct clutch bushing.
Maximum inside diameter: 47.07 mm (1.8531 in.)
If the inside diameter is greater than the maximum, replace the direct clutch.
ASSEMBLY OF DIRECT CLUTCH
1. INSTALL CLUTCH PISTON IN DIRECT CLUTCH DRUM
a. Install new O-rings to the piston. Coat the O-rings with ATF.
b. Being careful not to damage the O-rings, press the piston into the drum with the cup side up.
2. INSTALL PISTON RETURN SPRING
a. Place the return spring and snap ring onto the piston.
b. Place SST on the spring retainer, and compress the return spring with a shop press.
SST 09350 - 32014 (09351 - 32070)
c. Install the snap ring with the snap ring pliers. Be sure the end gap of snap ring is not aligned with the spring retainer claw.
