Tundra 2WD V6-3.4L (5VZ-FE) (2004)
/Page-1374004.png)
a. Using a screwdriver, remove the No. 2 assist grip plug. Tape the screwdriver tip before use.
b. Remove the 2 screws and assist grip.
c. Use the same manner described above to the other side.
18. REMOVE CENTER PILLAR GARNISH UPPER LH
a. Using a clip remover, remove the clip labeled A, clip labeled B and garnish.
19. REMOVE CENTER PILLAR GARNISH UPPER RH
HINT: Use the same procedures described for the RH side.
20. REMOVE CENTER PILLAR GARNISH LOWER LH
Using a screwdriver, remove the 4 clips and garnish.
HINT: Tape the screwdriver tip before use.
21. REMOVE CENTER PILLAR GARNISH LOWER RH
HINT: Use the same procedures described for the RH side.
22. REMOVE QUARTER TRIM PANEL LOWER LH
