Tundra 2WD V6-3.4L (5VZ-FE) (2004)
/Page-921001.png)
Parking Brake Pedal: Service and Repair
PARKING BRAKE PEDAL
REMOVAL
1. REMOVE SCUFF PLATE LH, COWL SIDE TRIM LH, LOWER FINISH PANEL AND NO. 2 HEATER TO REGISTER DUCT
2. REMOVE PARKING BRAKE PEDAL ASSEMBLY
a. Disconnect the parking brake switch connector.
b. Remove the lock nut and adjusting nut from the parking brake wire.
c. Remove the clip and parking brake wire.
d. Remove the 4 bolts and parking brake pedal assembly.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
INSTALLATION
Installation is in the reverse order of removal.
