Tundra 2WD V6-3.4L (5VZ-FE) (2004)
K.
Install the ground strap to the new bolt position indicated by the arrow.
Torque: 30 - 50 N.m
(300 - 520 kgf.cm, 261 - 435 in.lbf)
HINT:
Tighten the bolt in the area where the front fender apron seal has been removed.
NOTE:
Tighten the ground strap at an angle of 300 or less as shown in the illustration so that the oil cooler does not interfere with the wire.
NOTE:
Route the engine No. 2 wire harness as shown in the illustration to prevent heat damage from the exhaust manifold.