Tundra 2WD V6-3.4L (5VZ-FE) (2004)
Air Bag Control Module: Component Tests and General Diagnostics
Collision / Non-Collision Inspections
INSPECTION
1. VEHICLE NOT INVOLVED IN COLLISION
Do a diagnostic system check.*
2. VEHICLE INVOLVED IN COLLISION AND AIRBAG IS NOT DEPLOYED
Do a diagnostic system check.*
3. VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED
Replace the airbag sensor assembly.
* Refer to SRS Warning Light Check, and How to Display and Read Diagnostic Trouble Codes.
See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/SRS Warning Light Check
See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Displaying & Reading Trouble Codes
Replacement Requirements
REPLACEMENT
In the following cases, replace the airbag sensor assembly.
-
If the SRS has been deployed in a collision.
-
If the airbag sensor assembly has been found to be faulty in troubleshooting.
-
If the airbag sensor assembly has been dropped.
CAUTION: Be sure to follow the correct procedure for removal and Installation of the airbag sensor assembly.