Tundra 2WD V6-3.4L (5VZ-FE) (2004)
/Page-1291002.png)
3. Using a screwdriver, remove the front pillar garnish.
HINT: Tape the screwdriver tip before use.
c. Using a screwdriver, remove the back panel upper garnish.
HINT: Tape the screwdriver tip before use.
d. Remove the bolt and front seat outer belt floor anchor.
e. Remove the quarter trim.
1. Using a screwdriver, remove the quarter trim belt hole cover.
HINT: Tape the screwdriver tip before use.
2. Using a screwdriver, remove the cap.
HINT: Tape the screwdriver tip before use.
