Tundra 2WD V6-3.4L (5VZ-FE) (2004)
/Page-1002002.png)
4. Double cab (12 V): INSPECT ACC RELAY AND ACC CUT RELAY CONTINUITY
If the continuity is not as specified, replace the switch.
5. Except double cab: INSPECT POWER OUTLET RELAY (Marking: PWR OUTLET) CONTINUITY
If the continuity is not as specified, replace the switch.
6. Double cab (115 V): INSPECT VOLTAGE INVERTER CIRCUIT
Disconnect the connector from the voltage inverter and check the connector on the wire harness side, as shown in the table.
If the result is not as specified, replace the inverter.
