Tundra 2WD V6-3.4L (5VZ-FE) (2004)
Compress and extend the shock absorber rod and check that there is no abnormal resistance or unusual operation sounds. If there is any abnormality,
replace the shock absorber with a new one.
NOTICE: When disposing of the shock absorber, see DISPOSAL.
DISPOSAL
1. FULLY EXTEND SHOCK ABSORBER ROD
2. DRILL HOLE TO REMOVE GAS FROM CYLINDER
Using a drill, make a hole in the cylinder, as shown in the illustration to discharge the gas inside.
CAUTION: The discharged gas is harmless, but be careful of chips which may fly up when drilling.
REPLACEMENT
REPLACE BUSHING
a. Using SST, 19 mm deep socket wrench and a press, re move the bushing.
SST 09632-36010
b. Using SST and a press, install a new bushing.
SST 09630-24014 (09620-24041), 09632-36010
INSTALLATION
1. INSTALL REAR SHOCK ABSORBER
a. Install the 2 retainers and cushion to the shock absorber.
b. Install the shock absorber, cushion and retainer with nut.
Torque: 20 Nm (200 kgf-cm, 15 ft. lbs.)