Tundra 2WD V6-4.0L (1GR-FE) (2005)
/Page-873004.png)
b. Using a hammer, tap the yoke until there is no clearance between the bearing outer race and snap ring.
6. CHECK SPIDER BEARING
a. Check that the spider bearing moves smoothly.
b. Check the spider bearing axial play.
Maximum bearing axial play:
4WD rear propeller shaft: 0 mm (0 inch)
2WD and 4WD front propeller shaft: 0.05 mm (0.0020 inch)
HINT: Install new spider bearings on the flange side using the procedure described above.
^
When replacing the rear propeller shaft spider on 4WD vehicles, be sure that the grease fitting assembly holes are facing in the direction
shown in the illustration.
