Tundra 2WD V8-4.6L (1UR-FE) (2010)
Remote Switch: Service and Repair
Removal
AUDIO / VISUAL: STEERING PAD SWITCH: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Steering Pad/Removal
3. REMOVE LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Steering Pad/Removal
4. REMOVE STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Steering
Pad/Removal
5. REMOVE STEERING PAD SWITCH ASSEMBLY
(a) Disconnect the connector.
(b) Remove the 2 screws.
(c) Detach the 4 pins and remove the steering pad switch.