Tundra 2WD V8-4.6L (1UR-FE) (2010)
Double Cab)/Removal
5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
6. REMOVE REAR DOOR SCUFF PLATE RH
(a) Remove the front door scuff plate See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Headlining (For
Double Cab)/Removal.
HINT
The procedures listed below are for the LH side.
7. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Roof Headlining (For Double Cab)/Removal
8. REMOVE DOOR CONTROL RECEIVER
(a) Disconnect the door control receiver connector.
(b) Remove the bolt and receiver.
Installation
DOOR LOCK: DOOR CONTROL RECEIVER (for Double Cab): INSTALLATION
1. INSTALL DOOR CONTROL RECEIVER
(a) Install the receiver with the bolt.
(b) Connect the door control receiver connector.
2. INSTALL LOWER QUARTER TRIM PANEL ASSEMBLY RH
3. INSTALL REAR DOOR SCUFF PLATE RH
(a) Install rear door scuff plate See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Headlining (For Double
Cab)/Installation.
HINT
The procedures listed below are for the LH side.
4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
5. INSTALL REAR SEAT ASSEMBLY See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for
Double Cab)/Installation
6. INSTALL SEAT FLOOR BOX See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for Double