Tundra 2WD V8-4.6L (1UR-FE) (2010)
HINT
Tape the screwdriver tip before use.
2. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH
(a) Using a screwdriver, detach the 2 clips and rear upper door armrest base panel. Then disconnect the connector.
HINT
Tape the screwdriver tip before use.
3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
(a) Detach the 4 claws and remove the power window regulator switch.
4. REMOVE REAR DOOR FRAME GARNISH LH
(a) Detach the 4 clips and remove the rear door frame garnish.
5. REMOVE COURTESY LIGHT ASSEMBLY
(a) Detach the claw and remove the courtesy light from the door trim.