Tundra 2WD V8-4.6L (1UR-FE) (2010)
/Page-2606001.png)
Lower Side Moulding / Trim: Service and Repair
Removal
EXTERIOR: SIDE MOULDING: REMOVAL
HINT
*
Use the same procedures for the RH side and LH side.
*
The procedures listed below are for the LH side.
*
When removing the moulding, heat the vehicle body and moulding using a heat light.
Standard heating temperature:
NOTICE:
Do not heat the vehicle body and moulding excessively.
1. REMOVE LOWER NO. 1 SIDE PANEL MOULDING LH
(a) Detach the 2 clips and remove the moulding.
