Tundra 2WD V8-4.6L (1UR-FE) (2010)
(b) w/ Illumination:
(1) Remove the 4 screws.
(2) Disconnect the connector and then remove the visor.
40. REMOVE VISOR ASSEMBLY RH
HINT
Use the same procedures described for the LH side.
41. REMOVE VISOR HOLDER (w/o Illumination)
HINT
Use the same procedure to remove the visor holder on the other side.
(a) Remove the screw and visor holder.
42. REMOVE ASSIST GRIP SUB-ASSEMBLY
HINT
Use the same procedure for the other 2 assist grips.
(a) Using a screwdriver, detach the 4 claws and remove the 2 assist grip covers.
HINT
Tape the screwdriver tip before use.
(b) Detach the 2 clips and remove the assist grip.
43. REMOVE ASSIST GRIP PLUG