Tundra 2WD V8-4.6L (1UR-FE) (2010)
(a) Install the side gate support.
NOTICE:
*
Install the side gate support while supporting the body by hand.
*
Check that the side gate support is engaged in the ball joint and it cannot be pulled out.
8. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH See: Lighting and Horns/Tail Lamp/Service and Repair/Removal and
Replacement/Installation
9. INSTALL TAIL GATE LOCK STRIKER
(a) Using a T40 "TORX" wrench, install the 2 tail gate lock strikers with the 4 screws.
Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)
10. INSTALL TAIL GATE LOCK KEY CYLINDER
(a) Install the tail gate lock cylinder with the snap ring.
11. INSTALL TAIL GATE HANDLE ASSEMBLY
(a) Install the tail gate handle with the 2 bolts.
Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)
12. INSTALL TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System) See: Accessories and Optional Equipment/Collision
Avoidance and Parking Assist Systems/Rear Vision Camera/Service and Repair/Installation
13. INSTALL TAIL GATE LOCK CONTROL LINK LH
(a) Install the control rod.
14. INSTALL TAIL GATE LOCK CONTROL LINK RH
(a) Install the control rod.