Tundra 2WD V8-4.6L (1UR-FE) (2010)
*
Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
*
This torque value is effective when union nut wrench is parallel to the torque wrench.
3. CONNECT REAR NO. 1 BRAKE TUBE
(a) Using a union nut wrench, connect the brake tube (labeled B) to the brake master cylinder.
without union nut wrench - Torque : 20 Nm (199 kgf-cm, 14 ft-lbf)
with union nut wrench - Torque : 18 Nm (186 kgf-cm, 13 ft-lbf)
*
Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
*
This torque value is effective when union nut wrench is parallel to the torque wrench.
4. CONNECT BRAKE FLUID LEVEL WARNING SWITCH CONNECTOR
(a) Connect the brake fluid level warning switch connector.
5. BLEED BRAKE SYSTEM See: Brake Bleeding/Service and Repair/Bleeding