Tundra 2WD V8-4.6L (1UR-FE) (2010)
Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)
15. INSTALL INTERMEDIATE LEVER TENSION SPRING
(a) Install the tension spring.
16. INSTALL PARKING BRAKE SHOE LEVER RH
HINT
Use the same procedures described for the LH side.
17. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY RH
HINT
Use the same procedures described for the LH side.
18. INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY RH
HINT
Use the same procedures described for the LH side.
19. INSTALL PARKING BRAKE SHOE RETURN SPRING RH
HINT
Use the same procedures described for the LH side.
20. CHECK PARKING BRAKE INSTALLATION See: Service and Repair/Reassembly
21. INSTALL REAR DISC RH
HINT
Use the same procedures described for the LH side.
22. ADJUST PARKING BRAKE SHOE CLEARANCE See: Adjustments
23. CONNECT REAR DISC BRAKE CYLINDER ASSEMBLY RH
HINT
Use the same procedures described for the LH side.
24. INSTALL REAR WHEEL RH See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service and Repair/Removal and
Replacement/Rear Shock Absorber/Installation
25. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY (for 3220 mm [10 ft. 6.8 in.] Wheelbase Type)
(a) Install the No. 1 cable support bracket with the 3 bolts (labeled A).