Tundra 2WD V8-4.6L (1UR-FE) (2010)
Wheel Speed Sensor: Service and Repair
Front Speed Sensor
Components
BRAKE CONTROL: FRONT SPEED SENSOR: COMPONENTS
Removal
BRAKE CONTROL: FRONT SPEED SENSOR: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
2. REMOVE FRONT WHEEL
3. REMOVE FRONT SKID CONTROL SENSOR WIRE LH
(a) Disconnect the connector (labeled A) from the front speed sensor.
(b) Detach the 3 clips (labeled B) and remove the clamp bolt (labeled C).
(c) Disconnect the connector (labeled D).