Tundra 2WD V8-4.6L (1UR-FE) (2010)
Radiator Cooling Fan: Service and Repair
Removal
1UR-FE COOLING: FAN: REMOVAL
1. REMOVE NO. 1 ENGINE UNDER COVER See: Engine/Engine Lubrication/Engine Oil/Service and Repair/Replacement
2. DRAIN ENGINE COOLANT See: Coolant/Service and Repair
3. REMOVE V-BANK COVER SUB-ASSEMBLY See: Engine/Service and Repair/Removal and Replacement/Engine Assembly/Removal
4. REMOVE AIR CLEANER ASSEMBLY See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair/Removal
5. REMOVE INLET RADIATOR HOSE
(a) Remove the radiator hose.
6. REMOVE FAN SHROUD
(a) Loosen the 4 nuts holding the fluid coupling fan
(b) Remove the fan and generator V-belt See: Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal.
(c) Disconnect the reservoir hose from the upper radiator tank.
(d) w/ Trailer Towing System:
Detach the claw to open the No. 1 flexible hose clamp.
(e) Remove the 2 bolts holding the fan shroud.
(f) Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.
NOTICE: