Tundra 2WD V8-4.6L (1UR-FE) (2010)
/Page-856002.png)
(a) Apply a light coat of engine oil to the O-ring.
(b) Install a new O-ring to the oil control valve.
(c) Install the oil control valve with the bolt.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(d) Connect the oil control valve connector.
5. INSTALL AIR CLEANER HOSE ASSEMBLY See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
6. INSTALL V-BANK COVER SUB-ASSEMBLY See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
