Tundra 2WD V8-4.6L (1UR-FE) (2010)
Power Distribution Module: Service and Repair
Removal
OTHER SYSTEM: VOLTAGE INVERTER (for CrewMax): REMOVAL
1. REMOVE BACK PANEL TRIM LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Headlining (for
CrewMax)/Removal
2. REMOVE BACK PANEL TRIM RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Headlining (for
CrewMax)/Removal
3. REMOVE REAR DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Headlining
(for CrewMax)/Removal
4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
5. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Roof Headlining (for CrewMax)/Removal
6. REMOVE VOLTAGE INVERTER ASSEMBLY
(a) Remove the 2 bolts.
(b) Disconnect the voltage inverter connector and removal the voltage inverter.