Tundra 2WD V8-4.6L (1UR-FE) (2010)
/Page-1121034.png)
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO POWER STEERING ECU (CANH, CANL)
OK -- REPLACE POWER STEERING ECU See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays and
Modules - Steering/Steering Control Module/Service and Repair/Removal
18. CHECK FOR SHORT TO B+ IN CAN BUS WIRE (CENTER AIRBAG SENSOR)
(a) Disconnect the J46 center airbag sensor connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
