Tundra 2WD V8-4.6L (1UR-FE) (2010)
/Page-88001.png)
Power Distribution Relay: Testing and Inspection
ACC Cut Relay
1UR-FE STARTING: ACC CUT RELAY: ON-VEHICLE INSPECTION
1. REMOVE ACC CUT RELAY
(a) Remove the clip.
(b) Detach the 2 clips and remove the cowl side trim board RH.
(c) Remove the relay.
2. INSPECT ACC CUT RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(b) If the result is not as specified, replace the relay.
3. INSTALL ACC CUT RELAY
(a) Install the relay.
(b) Attach the 2 clips to install the cowl side trim board RH.
(c) Install the clip.
