toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Engine - Controls - Non-Linear Acceleration From A Stop|Page 334 > < Engine Controls - ECM Update For Shift Performance|Page 329
Page 1
background image

Engine Control Module: All Technical Service Bulletins
Engine - Controls - Non-Linear Acceleration From A Stop

T-SB-0273-10

September 28, 2010

Non-Linear Acceleration from a Stop

Service Category
Engine/Hybrid System

Section
Engine Control

Market
USA

Applicability

Introduction

Some 2010 model year Tundra vehicles with the 1UR-FE (4.6 L) engine may exhibit non-linear acceleration from a stop under certain conditions of low
engine rpm with high engine load. The Engine Control Module/ECM (SAE term: Powertrain Control Module/PCM) logic has been revised to address
this condition. Use the following repair procedure to recalibrate the ECM (PCM).

Calibration Information

Warranty Information

Applicable Warranty

^

This repair is covered under the Toyota Federal Emission Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first,
from the vehicle's in-service date.

^

Warranty application is limited to occurrence of the specified condition described in this bulletin.

Engine - Controls - Non-Linear Acceleration From A Stop|Page 334 > < Engine Controls - ECM Update For Shift Performance|Page 329