Tundra 2WD V8-4.6L (1UR-FE) (2010)
/Page-2297003.png)
Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for Floor Shift Type)/Removal
4. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for Floor Shift Type)/Removal
5. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for Floor Shift Type)/Removal
6. REMOVE CONSOLE BOX CARPET
7. REMOVE REAR CONSOLE BOX ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Instrument Panel Safety Pad (for Floor Shift Type)/Removal
8. REMOVE FRONT CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal
and Replacement/Instrument Panel Safety Pad (for Floor Shift Type)/Removal
9. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
(a) Disconnect the holder (with connectors).
(b) Remove the 3 bolts and airbag sensor.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type): INSTALLATION
1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the ignition switch is OFF.
(b) Check that the cable is disconnected from the battery negative (-) terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
(c) Install the airbag sensor with the 3 bolts.
Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)
NOTICE:
*
If the center airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector,
replace it with a new one.
*
When installing the center airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not
pinched between other parts.
(d) Check that there is no looseness in the installation parts of the center airbag sensor.
