Tundra 2WD V8-4.6L (1UR-FE) (2010)
Door/Service and Repair/Front Door (for Regular Cab)/Disassembly
4. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (for Front Side) See: Body and Frame/Doors, Hood and
Trunk/Doors/Front Door/Service and Repair/Front Door (for Regular Cab)/Disassembly
5. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH (for Front Side) See: Body and Frame/Doors, Hood and
Trunk/Doors/Front Door/Service and Repair/Front Door (for Regular Cab)/Disassembly
6. REMOVE COURTESY LIGHT ASSEMBLY (for Front Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Front Door (for Regular Cab)/Disassembly
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Service and Repair/Front Door (for Regular Cab)/Disassembly
8. REMOVE FRONT SIDE AIRBAG SENSOR
(a) Disconnect the connector.
(b) Remove the screw and side airbag sensor.
9. REMOVE FRONT DOOR SCUFF PLATE LH (for Rear Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Roof Headlining (For Regular Cab)/Removal
10. REMOVE REAR SIDE AIRBAG SENSOR
(a) Remove the bolt and side airbag sensor from the body.
(b) Disconnect the connector.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR (for Regular Cab): INSTALLATION
1. INSTALL FRONT SIDE AIRBAG SENSOR
(a) Check that the ignition switch is OFF.