Tundra 2WD V8-4.6L (1UR-FE) (2010)
9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY
(a) Using a screwdriver, detach the 2 claws and open the seat belt anchor cover as shown in the illustration.
HINT
Tape the screwdriver tip before use.
(b) Remove the bolt and disconnect the seat belt's shoulder anchor.
(c) Disconnect the pretensioner connector as shown in the illustration.
(d) Remove the 2 bolts and seat belt.
Installation
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY (for Regular Cab): INSTALLATION
HINT
*
Use the same procedures for the LH side and RH side.
*
The procedures listed below are for the LH side.
1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY