Tundra 2WD V8-4.6L (1UR-FE) (2010)
Door/Service and Repair/Front Door (for Double Cab)/Disassembly
4. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH (for Front Side) See: Body and Frame/Doors, Hood and
Trunk/Doors/Front Door/Service and Repair/Front Door (for Double Cab)/Disassembly
5. REMOVE COURTESY LIGHT ASSEMBLY (for Front Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Front Door (for Double Cab)/Disassembly
6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Service and Repair/Front Door (for Double Cab)/Disassembly
7. REMOVE FRONT SIDE AIRBAG SENSOR
(a) Disconnect the connector.
(b) Remove the screw and side airbag sensor.
8. REMOVE REAR SEAT ASSEMBLY (for Rear Side)
(a) Remove the rear seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for Double
Cab)/Removal.
9. REMOVE REAR DOOR SCUFF PLATE LH (for Rear Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof
Headlining (For Double Cab)/Removal
10. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Rear Side)
11. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH (for Rear Side) See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Roof Headlining (For Double Cab)/Removal
12. REMOVE REAR SIDE AIRBAG SENSOR
(a) Remove the bolt and side airbag sensor.
(b) Disconnect the connector.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR (for CrewMax): INSTALLATION
1. INSTALL FRONT SIDE AIRBAG SENSOR
(a) Check that the ignition switch is OFF.