Tundra 2WD V8-4.6L (1UR-FE) (2010)
/Page-295007.png)
(e) Attach the 3 clips (labeled F).
NOTICE:
*
When installing the clips, do not twist the wire harness.
*
When installing the clips, securely insert them as shown in the illustration.
(f) Connect the speed sensor connector (labeled G).
NOTICE:
Securely connect the connector.
7. INSTALL FRONT WHEEL See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service and Repair/Removal and
Replacement/Front Shock Absorber/Installation
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. CHECK SPEED SENSOR SIGNAL
(a) Check the speed sensor signal See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Scan
Tool Testing and Procedures/Test Mode Procedure.
