Tundra 2WD V8-4.6L (1UR-FE) (2010)
/Page-554005.png)
(b) Check that the cable is disconnected from the battery negative (-) terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
(c) Install the door airbag sensor with the screw.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
*
If the door airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector,
replace it with a new one.
*
When installing the door airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not
pinched between other parts.
(d) Check that there is no looseness in the installation parts of the door airbag sensor.
(e) Connect the connector.
2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Service and Repair/Front Door (for Double Cab)/Reassembly
3. INSTALL COURTESY LIGHT ASSEMBLY (for Front Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Front Door (for Double Cab)/Reassembly
4. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH (for Front Side) See: Body and Frame/Doors, Hood and
Trunk/Doors/Front Door/Service and Repair/Front Door (for Double Cab)/Reassembly
5. INSTALL FRONT UPPER ARMREST BASE PANEL LH (for Front Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Service and Repair/Front Door (for Double Cab)/Reassembly
6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH (for Front Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Service and Repair/Front Door (for Double Cab)/Reassembly
7. INSTALL REAR SIDE AIRBAG SENSOR
(a) Check that the ignition switch is OFF.
(b) Check that the cable is disconnected from the battery negative (-) terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
(c) Install the side airbag sensor with the bolt.
