Tundra 2WD V8-4.6L (1UR-FE) (2010)
(b) Hang the plunger of the magnet starter switch onto the drive lever from the upper side.
(c) Install the magnet starter switch with the 2 nuts.
Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)
(d) Connect the lead wire to the magnet starter switch and connect it with the nut.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
Disassembly
1UR-FE STARTING: STARTER (for 2.0 kW Type): DISASSEMBLY
1. REMOVE MAGNET STARTER SWITCH ASSEMBLY
(a) Remove the nut, and disconnect the lead wire from the magnet starter switch.
(b) Remove the 2 nuts and magnet starter switch.
2. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
(a) Using a T30 "TORX" socket wrench, remove the 2 bolts.
(b) Pull out the yoke and starter commutator end frame assembly together with the armature.