Tundra 2WD V8-4.6L (1UR-FE) (2010)
/Page-2089002.png)
Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)
NOTICE:
*
No further tightening is required once the nut is tightened with the specified torque.
*
Check that there is no foreign matter on the washer and nut.
*
Check that there is no oil, water or lubricant around the rim hole, tire pressure warning valve, washer and nut. Failing to do so
may result in improper installation.
(d) Set the wheel disc to a mounting machine and install the lower tire bead. Position the main body of the tire pressure warning valve and
transmitter in the shaded area as shown in the illustration.
NOTICE:
*
If the tire pressure warning valve and transmitter is positioned outside this area, the tire bead will interfere with the tire pressure
warning valve and transmitter, and may cause damage to it.
*
If the use of lubricant is required when installing the bead, do not apply the lubricant directly to the tire pressure warning valve
and transmitter.
(e) Install the upper bead.
NOTICE:
Make sure that the tire bead and tool do not interfere with the main body of the tire pressure warning valve and transmitter and that
the tire pressure warning valve and transmitter is not clamped by the bead.
(f) Inflate the tire. Retighten the nut to the specified torque and then check for air leaks with soapy water.
Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)
NOTICE:
