Tundra 2WD V8-4.6L (1UR-FE) (2010)
(a) Place matchmarks on the bearing cap and differential carrier.
(b) Remove the 4 bolts and 2 differential bearing caps.
(c) Remove the differential case from the differential carrier.
HINT
Tag the 2 case bearing outer races to show the location for reassembly.
15. REMOVE REAR DIFFERENTIAL DRIVE PINION
(a) Remove the differential drive pinion and bearing spacer from the differential carrier.
16. REMOVE REAR DRIVE PINION REAR TAPERED ROLLER BEARING
(a) Using SST and a press, press out the bearing (inner race).
SST : 09950-00020
(b) If either the drive pinion or ring gear is damaged, replace them as a set.
17. REMOVE REAR DIFFERENTIAL DRIVE PINION PLATE WASHER
18. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING
(a) Using a brass bar and hammer, tap out the bearing (outer race).