Tundra 2WD V8-4.6L (1UR-FE) (2010)
(b) Remove the O-ring.
14. REMOVE REAR AXLE SHAFT OIL SEAL
(a) Using SST, tap out the oil seal.
SST : 09308-00010
NOTICE:
Be careful not to damage the axle housing hole.
Installation
AXLE: REAR AXLE SHAFT: INSTALLATION
1. INSTALL REAR AXLE SHAFT OIL SEAL
(a) Using SST and a hammer, tap in a new oil seal.
SST : 09950-60020
09951-00770
SST : 09950-70010
09951-07150
(b) Apply MP grease to the lip of the oil seal.
NOTICE:
Do not allow foreign matter, etc. to contact the axle shaft housing hole.
2. INSTALL REAR AXLE SHAFT
(a) Apply MP grease to a new O-ring.