Tundra 4WD V6-3.4L (5VZ-FE) (2004)
11.
4WD:
Remove oil seal (inside).
A.
Mount the axle hub in a soft jaw vise.
HINT:
Install nuts on the hub bolts, close the vise until it holds the hub nuts. Do not tighten further (refer to the illustration above).
B.
Using a screwdriver, remove the oil seal (inside).
12.
2WD:
Remove lock nut and ABS speed sensor rotor (with ABS) or spacer (without ABS).
Using a chisel and hammer, loosen the staked part of the lock nut.
NOTE:
Be careful not to damage the bushing.
A.
Using the following SST, remove the lock nut.
SST P/N: 00002-00909 (09318-12010)
NOTE:
Do NOT use air wrench.
B.
Remove the ABS speed sensor rotor or spacer.
NOTE:
Take care not to scratch the serration of the speed sensor rotor.
13.
Remove axle hub from steering knuckle.
A.
Remove the 4 bolts and shift the dust cover toward the hub side (outside).
B.
Using the following SSTs, remove the axle hub from the steering knuckle.
SST P/N:
09710-28012-01 (09710-07031)
SST P/N:
09950-40011(09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04031, 09957-04010, 09958-04011)
HINT:
If necessary, use a press to remove the axle hub from the steering knuckle.
C.
Remove the dust cover from the steering knuckle.
D.
4WD:
Remove the bearing spacer and ABS speed sensor rotor (with/ABS) or spacer (without ABS).
NOTE:
Take care not to scratch the serration of the speed sensor rotor.
14.
Remove oil seal (outside). Using a screwdriver, remove the oil seal (outside) from the steering knuckle.
15.
Remove bearing from steering knuckle.