Tundra 4WD V6-3.4L (5VZ-FE) (2004)
/Page-420005.png)
c. Tap the lock plate with a soft-faced hammer so that there is no gap between it and the tank.
4. ASSEMBLE SST
SST 09230-01010, 09231-14010
a. Install the punch assembly to the overhaul handle, inserting it in the hole in part "A" as shown in the illustration.
b. While gripping the handle, adjust the stopper bolt so that dimension "B" shown in the diagram.
Dimension "B": 8.4 mm (0.34 inch)
5. CAULK LOCK PLATE
a. Lightly press SST against the lock plate in the order shown in the illustration After repeating this a few times, fully caulk the lock plate by
squeezing the handle until stopped by the stopper bolt.
SST 09230-01010
HINT:
