Tundra 4WD V6-3.4L (5VZ-FE) (2004)
a. Install the front airbag sensors with the 4 bolts.
Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)
HINT: Install the front airbag sensor with the arrow on the sensor facing toward the front of the vehicle.
NOTE:
-
Connection of the connector is done after the sensor has been installed.
-
Make sure the sensor is installed with the specified torque.
-
If the sensor has been dropped, or there are cracks, dents or other defects in the case, brackets or connector, replace the removed sensor with a
new one.
-
The front sensor is equipped with an electrical connection check mechanism. Be sure to lock this mechanism securely when connecting the
connector, if the connector is not securely locked, a malfunction code will be detected by the diagnostic system.
b. Connect the front airbag sensor connectors.
c. Install the air cleaner assembly.
d. 2UZ-FE engine:
Install the battery tray, battery and battery carrier.