Tundra 4WD V6-3.4L (5VZ-FE) (2004)
/Page-150001.png)
Hazard Warning Switch: Testing and Inspection
1. Double cab: INSPECT HAZARD WARNING SWITCH CONTINUITY
(a) Remove the integration control panel.
(b) Check that the continuity exists between terminal 16 and terminal 10 with the switch ON.
(c) Check that no continuity exists between terminal 16 and terminal 10 with the switch OFP
If the continuity is not as specified, replace the panel.
2. Except double cab: INSPECT HAZARD WARNING SWITCH CONTINUITY
(a) Remove the integration control panel.
(b) Check that the continuity exists between terminal 17 and terminal 1 with the switch ON.
(c) Check that no continuity exists between terminal 17 and terminal 1 with the switch OFP
If the continuity is not as specified, replace the panel.
