Tundra 4WD V6-3.4L (5VZ-FE) (2004)
/Page-1120016.png)
SST 09922-10010
Torque: 51 Nm (520 kgf-cm, 38 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
d. Recheck the total preload.
Preload (turning): 1.0 - 1.45 Nm (10 - 14.5 kgf-cm, 8.7 - 12.6 inch lbs.)
e. Remove the RH and LH rack ends.
16. INSTALL RH AND LH CLAW WASHERS AND RACK ENDS
a. Install a new claw washer, and temporarily install the rack end.
HINT: Align the claws of the claw washer with the steering rack grooves.
b. Using a spanner to hold the steering rack steady, and using SST, torque the rack end.
SST 09922-10010
Torque: 76 Nm (770 kgf-cm, 56 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using a brass bar and hammer, stake the washer.
NOTICE: Avoid any impact on the rack.
d. Employ the same manner described above to the other side.
17. INSTALL RH AND LH RACK BOOTS, CLAMPS AND CLIPS
