Tundra 4WD V6-3.4L (5VZ-FE) (2004)
Clutch Master Cylinder: Service and Repair
REMOVAL
1. REMOVE FILLER CAP AND FLOAT FROM RESERVOIR
2. DRAW OUT BRAKE FLUID WITH SYRINGE
NOTICE: Do not let brake fluid remain on a painted surface. Wash it off immediately.
3. DISCONNECT CLUTCH LINE FROM MASTER CYLINDER
Using SST, disconnect the line. Use a container to catch the fluid.
SST 09023-00100
4. REMOVE CLIP AND CLEVIS PIN
a. Using needle-nose pliers, remove the clip.
b. Remove the clevis pin and wave washer.
5. REMOVE 2 MOUNTING NUTS AND PULL OUT MASTER CYLINDER
6. REMOVE GASKET
DISASSEMBLY