Tundra 4WD V6-3.4L (5VZ-FE) (2004)
4. REMOVE OIL SEAL
Using SST, remove the oil seal.
SST 09308-10010
5. REMOVE FRONT BEARING
Using SST, remove the front bearing from the drive pinion.
SST 09556-22010
6. REMOVE BEARING SPACER
a. Remove the 2 washers.
b. Remove the bearing spacer.
7. INSTALL NEW BEARING SPACER
a. Install a new bearing spacer.
b. Install the 2 washers.
8. INSTALL FRONT BEARING
a. Place the front bearing.
b. Using SST and the companion flange, install the front bearing then remove the companion flange.
SST 09950-30012 (09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03050)
9. INSTALL NEW OIL SEAL
a. Coat a new oil seal lip with MP grease.
b. Using SST and a plastic hammer, install the oil seal until its surface is flush with the differential carrier end.
SST 09316-12010, 09649-17010
HINT: Connect 2 SST with vinyl tape.