Tundra 4WD V6-3.4L (5VZ-FE) (2004)
b. Remove the 4 bolts, washers and nuts, disconnect the propeller shaft from the differential.
c. Suspend the front side of the propeller shaft.
d. Place matchmarks on the transfer and propeller shaft flanges.
e. Remove the 4 nuts and washers.
f.
Remove the propeller shaft from the transfer.
2. REMOVE REAR PROPELLER SHAFT
a. Place matchmarks on the transfer and propeller shaft flanges.
b. Remove the 4 nuts and washers, and disconnect the propeller shaft from the transfer.
c. Suspend the front side of the propeller shaft.
d. Remove the 2 mounting bolts and center support bearing.
e. Place matchmarks on the differential and propeller shaft flanges.
f.
Remove the 4 bolts, washers and nuts.
g. Remove the propeller shaft from the differential.
INSTALLATION
1. INSTALL FRONT PROPELLER SHAFT
a. Align the matchmarks on the propeller shaft and differential flanges, and connect the flanges with the 4 bolts, nuts and washers.
b. Torque the 4 bolts.
Torque: 74 Nm (750 kgf-cm, 54 ft. lbs.)
c. Align the matchmarks on the propeller shaft and transfer flanges, and connect the flanges with the 4 nuts and washers.
d. Torque the 4 nuts.
Torque: 74 Nm (750 kgf-cm, 54 ft. lbs.)
2. INSTALL REAR PROPELLER SHAFT
a. Align the matchmarks on the propeller shaft and differential flanges, and connect the flanges with the 4 bolts, washers and nuts.
b. Torque the 4 bolts.
Torque: 74 Nm (750 kgf-cm, 54 ft. lbs.)